LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 911 Targa 4 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 63 - Bumpers - 911 CARRERA (992) >> WM, 635019 Removing And Installing Rear Bumper >> Installing Rear Bumper

Installing Rear Bumper

  1. Installation is performed in reverse order.
  2. Lift up the bumper, guide it in -A-  and set it down at its end position -B-  . Check the gap between the seal and heat shield -1-  during installation.
    G14263913Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Installing rear bumper 

  3. Check that the seal is fitted fully on the heat shield.
  4. Tighten screws to > Tightening torque 23 (17 ft.lb) Nm  .
scientia non olet · About LEMON Manuals