Setting Flow-Form Rivets

Information 

We recommend that you use punch D19 with thread. Screw punch D19 securely in the piston rod using the supplied wrench set.

Information 

Adapt the pressure setting on the > VAS 6790 - Compact Booster  to the existing plate thicknesses of the connection points:

• Connection thickness 2 - 3 mm: Pressure setting 3 
• Connection thickness 3 - 4 mm: Pressure setting 3.5 
• Connection thickness 4 - 5 mm: Pressure setting 4 

The pressed-outor pulled-out punch rivets and drilled-out penetrated joints can be replaced by flow-form rivets during repairs if a low joint height is also required. Contrary to the standard procedure, all riveted joints are also bonded.

1. Straighten the flanges at the rivet point separately on both sheetmetal panels using > VAS 6790 - Compact Booster  and punch and bottom die pair -D17 + D17-  from > VAS 6790/2 - Supplementary Riveting Set. 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Straightening sheetmetal flanges

2. Punch and stamp holes fer flow-form rivets through both sheetmetal panels using > VAS 6790 - Compact Booster  and punch and bottom die pair -D18 or D19with D20-  from > VAS 6790/65 - Rivet inserts  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Punching and stamping holes

3. Set and press in flow-form rivets using > VAS 6790 - Compact Booster  and punch and bottom die pair -D21 + S9-  from > VAS 6790/65 - Rivet inserts. 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Setting flow-form rivets