Preparing For Stud Welding

Information 

The following description is intended only as a guide. A description of the steps involved and the various areas of application can be found in the operating instructions provided with the respective device.

Information 

The support fixture to be used and the required gas pipe will vary depending on the type of bolt to be welded. See operating instructions provided with the device for details of the correct pairing.

1. Remove paint and oxide coating on clamping points for earth clamps.
2. Attach earth clamps of welder > VAS 852001 - Dent removal unit  close to the rivet point using the highest possible clamping force. The welding point should be centred between the two earth clamps.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Attaching earth clamps

3. Remove paint and oxide coating at the welding point.
4. If necessary, connect inert gas and set the minimum flow rate according to the welding parameters in the table below.
5. Fit welding gun -1-  with the gas nozzle -2-  required for the stud and a suitable stud holder -3-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Fitting welding gun

6. Set welding parameters on the stud welder in accordance with the table below.