Installing Corner Panel Of Rear Cover Plate (Cabriolet)

Information

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
• Do not begin bonding work until all materials and tools necessary for later repair work are available.

1. Apply adhesive evenly in the marked area on the joint area of the body. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas

2. Apply adhesive evenly on the bonding surfaces of the corner panel.

   > Application depth 0.5 mm 

   Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding surfaces

3. Rivet in rear corner panel using blind rivets.

   > BLIND RIVET 999.190.229.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Blind rivets

4. Rivet in rear corner panel using flow-form rivets.

   > 5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Flow-form rivets

   PARTS DESCRIPTION 

   A	> RIVET 9A7.008.606.00
   B	> RIVET 9A7.008.607.00