Removing windscreen
WARNING:
Vehicle windows removed and installed incorrectly
- Danger of cuts
- Risk of eye injuries
→ Wear personal protective gear.
→ Always shut off power supply when replacing cutting knife.
Installation position
- Release and disconnect electric plug connection -1-
for antenna amplifier -2-
at the left and right.
Antenna amplifier
Information
Too much force can damage the component.
- 1.1 Detach headliner -3- as far as the B-pillar and pull it down carefully.
- 1.2
Release and unplug electric plug connection -1-
.
Information
- The procedure for removing car windows is described in
- Remove the windscreen using cutting wire or cutting cord.
Information
- To prevent damage, make sure that the vehicle identification number (VIN) is completely masked by the protective film when piercing the adhesive bead.
- 2.1 The adhesive bead on the windscreen is pierced from the inside out in the vehicle identification number area.