Installing Rear Spoiler Motor

Information 

• In the lower position (after moving mechanically to the limit stop), the slot must be aligned with the bar. 

1. Prepare drive unit for installation.
   1. 1.1 Move drive unit to the lower position.
   1. 1.1.1 Turn both drive shafts by hand until the hinges reach the lower limit stops.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

2. Connect wire harness.
   1. 2.1 Push on connector on the motor.
3. Position motor.
   1. 3.1 Carefully insert drive shafts on the motor.
   2. 3.2 Guide motor with drive shafts into the housing and position it in the bearings -Arrows-  .

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   3. 3.3 Fit seal on the housing all the way around and engage it on the positioning pins.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

4. Close motor housing.
   1. 4.1 Position cover on the housing.
   2. 4.2 Engage clip connection at the top and bottom.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.