Assembly Instructions For Retainer Plate For Headlight-Washer Spray Nozzle

Information 

Surface condition 

• The bonding surfaces must be free from oil, dirt, moisture, and paint and oxide layers. 
• Clean bonding surfaces with isopropanol and using clean, lint-free disposable cloths. 
• Do not leave bonding surfaces exposed for more than 2 hours, otherwise bonding surfaces will have to be cleaned again. 

Information 

Temperature 

• A processing temperature of between 20°C and 25°C applies to the surrounding area and materials. 

Information 

Applying adhesive 

• Apply adhesive using the EPX application system (from 3M). 
• Only use original mixing nozzles. 
• Processing time: 2-3 minutes. If this is exceeded, use a new mixing nozzle. 
• Apply adhesive in such a way that the bead of adhesive is pressed in by approx. 50% when joining components. 
• Affix the retainer plate within a processing time of 2-3 minutes. 

Information 

Final bonding strength 

• The required handling strength is achieved after approx. 3 hours. Do not move affixed retainer plates before then. 
• The final bonding strength is achieved after approx. 24 hours. Do not apply pressure on the bonded joint during this time. 
• At 70°C, the final bonding strength is achieved after approx. 30 minutes. Do not apply pressure on the bonded joint during this time. 

1. Clean the front apron -1-  at the left and right in the marked area -A-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

2. Mask the front apron -1-  at the left and right in the marked area -A-  with adhesive tape -2-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

3. Paint the front apron -1-  .
4. Remove adhesive tape -2-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

5. Clean the front apron -1-  at the left and right in the marked area -A-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

6. Apply adhesive to area -A-  on the retainer plate -1-  .

   >Application depth 3 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

7. Affix retainer plate -1-  in the front apron -2-  (-arrow-  ).

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

8. Secure the retainer plate -1-  with adhesive tape -2-  on the front apron -3-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

9. Remove securing tape after 3 hours at the earliest.