Removing And Installing Door Entry Guard

Information 

To prevent damage, use a suitable tool as a support during removal at accessible connection points.

1. Remove expansion rivets -1-  and remove masking panel -2-  from the front wing -3-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

2. Remove clips -2-  on sill cover -1-  at the bottom.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

3. Remove clip -1-  at the front.
4. Unscrew and remove screw -2-  at the front.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

5. Unscrew and remove screws -1-  at the rear.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

6. Remove clips -2-  on sill cover -1-  at the top.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

7. First pull sill cover -1-  in the side panel area out of the retaining strips -2-  and remove it.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Information 

   • Fit new grommets before installation. 
   • Check clips for damage and replace them if necessary. 
8. Installation is performed in reverse order.