LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 718 Boxster S, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> 96 Lights, Lamps, Switches-Interior, Anti-Theft Protection -- 982 - BOXSTER/CAYMAN >> WM, 962755 Replacing Switch Console >> Replacing Switch Console

Replacing Switch Console

  1. Connect the Tester to the vehicle and start it. Switch on ignition.
  2. Select the vehicle type if required.
  3. Select the Air conditioning  control unit in the overview.  The message "Create Vehicle Analysis Log (VAL)?" appears. Press F11 to continue.
  4. Coding/programming  must be selected.
  5. Automatic coding  must now be selected. Press F12 to start.
  6. The Tester displays the message Coding completed successfully. 
  7. Select Drive links/checks  and press F12.
  8. Select Servo motors  and press F12.
  9. Automatic addressing of LIN servo motors  must be selected. Press F12 to continue and then press F8 to start.
  10. Teach LIN servo motor limit stops  must be selected. Press F12 to continue and then press F8 to start.
  11. Air-conditioning compressor  must be selected. Press F12 to continue.

    Information 

    • The Compressor run-in function can only be carried out when the engine is running. 
    • Preconditions for compressor run-in can be found in  > 9900 - PIWIS Tester 3 by selecting the Compressor run-in function in the air conditioning control unit and pressing F1. 
    • Specifications in  > 9900 - PIWIS Tester 3 have priority and take precedence over the specifications in the description. 
    • If the Compressor run-in function cannot be activated, then the Reset compressor run-in function must be carried out first. 
    • Then start the Compressor run-in function again. 
  12. Start the engine.
  13. Reset compressor run-in  must now be selected. Press F12 to continue and then press F8 to start.
    1. 13.1 A compressor run-in remaining time of 150 s  must be set.
  14. Compressor run-in  must be selected. Press F12 to continue and then press F8 to start.
  15. Read out fault memory and erase it if necessary.
  16. Check the function of the switch console during a test drive and read out the fault memory.
scientia non olet · About LEMON Manuals