Subsequent Work
WARNING: This page is about a different variant/trim than selected.
Information
- After replacing or repairing the PDK transmission, the transmission control unit must be calibrated using the PIWIS Tester → "major calibration".
Information
- The illustrations shown here are not of GT4/Spyder models and may differ slightly.
Information
- The coolant hoses must lock with an audible click when pushed into the plug-in couplings.
- Lift engine with transmission off the unit elevating platform.
- Position rear-axle module on > VAS 6832 - Master Gear unit elevating platform.
Get another person to help with this step.
- Fit engine with transmission on the rear-axle module and > VAS 6832/6 - assembly fixture - Boxster.
- Remove or dismantle lifting equipment.
- Install rear silencer with holder.
- Install the engine.