Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Wheel to wheel hub on front and rear axle, M14 x 1.5 | Do not grease thread, shank and under the head (between screw head bearing surface and spherical cap ring) of the wheel bolts. Do not grease bearing surface of the spherical cap facing the wheel rim. If heavily soiled, clean bolts first with a lint-free cloth. Replace damaged wheel bolts (rework not permitted). |
Tightening torque | 160 Nm (118 ftlb.) | ||
| Thickness tolerance of brake discs (max.) | Measured value | 0.02 mm | |||
| Lateral runout of wheel hub (max.) | Measured value | 0.03 mm | |||
| Lateral runout of brake disc when installed (max.) | Measured value | 0.06 mm |