Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Install cover for rear underbody.
> WM, 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY .
- Activate the Drain fuel tank
function for 30 seconds using the PIWIS Tester
.
This function can be found in the Drive links/checks menu.
- Use the PIWIS Tester
to bleed the high-pressure system using the function.
200107 BLEEDING FUEL SYSTEM ON HIGH-PRESSURE SIDE - FIRST START FUNCTION .
- Perform a test drive. A high-pressure adaptation is only necessary if the high-pressure pump has been replaced.