Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Clutch to flywheel |
M7 x 16 - tighten crosswise and in several steps |
Initial tightening |
10 Nm (7.5 ftlb.) |
|
|
| Clutch to flywheel |
M7 x 16 - tighten crosswise - pre-set 15 Nm (11 ftlb.) on torque angle tool |
Torque angle |
60 Grad |
|
|