Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Tank vent valve to turbocharger, | M6 x 20 screw (2.0 l and 2.5 l only) | Tightening torque | 10 Nm (7.5 ftlb.) (7.4 ftlb.) | ||
| Turbocharger to holder, top (heat shield) | Collar nut, M8 | Tightening torque | 16 Nm (12 ftlb.) | ||
| Turbocharger to exhaust manifold | Replace M8 nuts | Tightening torque | 25 Nm (19 ftlb.) | ||
| Stud on turbocharger/exhaust manifold flange | M8 stud, replace - coat thread with Microgleit LP 475 | Tightening torque | 12 Nm (9 ftlb.) | + 4 Nm (3 ftlb.) | |
| Intake manifold to turbocharger | M6 | Tightening torque | 12 Nm (9 ftlb.) | ||
| Coolant supply lines to turbocharger | Counter sunk screw, M6 x 10 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Turbocharger coolant lines to engine | M6 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Oil line for pressure line to turbocharger | M6 x 10 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Heat protection to oil tank | M6 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Screw for clamp | Tightening torque | 20 Nm (15 ftlb.) |