Technical Values

WARNING: This page is about a different variant/trim than selected.

Location	Description	Type	Basic value	Tolerance 1
Transmission mount to body	Screw, M8 x 50 with collar nut	Tightening torque	33 Nm (24.3 ftlb.)
Coolant drain plug	Hexagon socket, M14 x 1.5 - replace sealing ring	Tightening torque	25 Nm (19 ftlb.)	+/- 2 Nm (1.5 ftlb.)
V strut to body	Item 2: Hexagon-head bolt M10 x 1.5 x 55/replace after every removal	Initial tightening	35 Nm (25.8 ftlb.)
V strut to body	Item 2: Hexagon-head bolt M10 x 1.5 x 55/replace after every removal	Final tightening	+ 60°
Rear axle carrier side part to body (rear)	Item 3: Screw M10 x 80/replace after every removal	initial tightening	30 Nm (22.1 ftlb.)
Rear axle carrier side part to body (rear)	Pos3: Screw M10 x 80/replace after every removal	final tightening	+ 90°
Rear axle carrier side part to body (front)	Item 5: Hexagon nut M10	Tightening torque	65 Nm (47.9 ftlb.)
Diagonal arm to body	Replace hexagon-head bolt M14 x 1.5 x 95 + hexagon nut	Initial tightening	80 Nm (59 ftlb.)
Diagonal arm to body	Replace hexagon-head bolt M14 x 1.5 x 95 + hexagon nut	Final tightening	+ 60°
Clutch slave cylinder to transmission	M8 screw	Tightening torque	23 Nm (17 ftlb.)
Holder and guide for shift linkage	Collar nut, M8	Tightening torque	23 Nm (17 ftlb.)
Engine to engine mount	Collar nut, M12 x 1.5	Initial tightening	40 Nm (30 ftlb.)
Engine to engine mount	Collar nut, M12 x 1.5	Final tightening torque angle	90 Grad
Ground strap to cylinder head 3-4	Torx screw, M8 x 20 (10.9)	Tightening torque	23 Nm (17 ftlb.)
Ground strap to body	Screw, M8	Tightening torque	23 Nm (17 ftlb.)
Strut to body	Screw, M10	Tightening torque	65 Nm (48 ftlb.)
Fastening screw securing refrigerant line to underbody connection point	M8 x 28	Tightening torque	14 Nm (10.5 ftlb.)
Fastening nuts (M8) for battery lines in power distributor		Tightening torque	12 Nm (9 ftlb.)	+/- 1 Nm (0.5 ftlb.)
Air guide for control unit to body	Plastic nut, M6	Tightening torque	3 Nm (2 ftlb.)