Installing Coolant Regulator Housing

WARNING: This page is about a different variant/trim than selected.

WARNING: Caustic fluids

Danger of chemical burns
- → Wear personal protective gear.
- → Ensure that there is good ventilation.
- → Avoid contact with caustic fluid.
- → If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.

Information

Coat O-rings, hoses and lines in the cooling system with Kluberplus Gel (Part No. 000.043.205.93).

Installation is performed in reverse order to removal.
Check seals and replace them if necessary.

Fastening screw securing coolant regulator housing to crankcase > Tightening torque 13 Nm (9.5 ftlb.) .