LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 718 Boxster Base, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> 42 Rear Wheel Suspension Drive Shaft 2.0L -- 982 - BOXSTER/CAYMAN >> WM, 427119 Removing And Installing Rear Spring Strut >> Subsequent Work

Subsequent Work

  1. Fit rear wheel.

    > 440519 REMOVING AND INSTALLING WHEEL - portion on "Installing"

    For vehicles with PCCB brake discs, use assembly aids (two assembly pins).

  2. Tighten the axle nut (securing drive shaft to wheel bearing housing). Also apply the brake (2nd mechanic required) while the vehicle is stationary on the ground. > Tightening torque 460 Nm (339.3 ftlb.) 
  3. Install covers.

    Boxster:  Install service covers in rear luggage compartment.

    > 700619 REMOVING AND INSTALLING TRIM PANEL FOR REAR LUGGAGE COMPARTMENT - portion on "Installing"

    Boxster Spyder:  Install rear luggage compartment trim panel.

    > 700619 REMOVING AND INSTALLING REAR LUGGAGE COMPARTMENT TRIM PANEL

    Cayman:  Install cover over spring-strut mount.

    Install rear cover

    > Refer to Removing and installing rear cover - portion on "Installing"

  4. Check wheel alignment values and make adjustments if necessary.

    > 449503 SUSPENSION ALIGNMENT COMPLETE - Portion on "Performing Suspension Alignment And Adjusting Vehicle"

scientia non olet · About LEMON Manuals