LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Taycan 4S >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Collision - 5X Body - General Information (Collision) (Y1A)) >> 5X00 Body - General Information (Collision) >> WM, 5X00IN22 Processing Body Foam Filler >> Processing Body Foam Filler >> Preparing Bonding Surfaces

Preparing Bonding Surfaces

WARNING: This page is about a different car, the 2023 Porsche Taycan and 2022 Porsche Taycan. However, it is still accessible from the selected car via links, so may be relevant.

Initial cleaning 

Remove sticky, solid layers such as dirt and rust.

Cleaning 

Then, clean the bonding flange areas using a lint-free cloth soaked in isopropanol or acetone until there are no more residues on the cloth.

Leave cleaned surfaces to dry off for 15 minutes; the bonding surfaces must be completely dry.

scientia non olet · About LEMON Manuals