Technical Values
WARNING: This page is about a different car, the 2023 Porsche Taycan and 2022 Porsche Taycan. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Dimension A | Distance from lower edge of A-pillar reinforcement | 347 mm | |||
| Bit | Diameter | 8 mm | |||
| Bit | Diameter | 8 mm | |||
| Edge to holes | Item A | Length | 12 mm | ||
| Hole to hole outside | Item B | Length | 25 mm | ||
| Hole to hole in rear | Item C | Length | 20 mm | ||
| Height of reinforcement plates | Item A | Length | 50 mm | ||
| Width of large reinforcement plate | Item B | Length | 110 mm | ||
| Width of small reinforcement plate | Item C | Length | 40 mm | ||
| Bit | Diameter | 8 mm | |||
| Edge to holes | Item A | Length | 12 mm | ||
| Hole to hole outside | Item B | Length | 25 mm | ||
| Hole to hole in rear | Item C | Length | 20 mm | ||
| Applying adhesive | Spread out evenly | Application depth | 0.5 mm | ||
| Applying adhesive | Spread out evenly | Application depth | 0.5 mm | ||
| Applying adhesive | Spread out evenly | Application depth | 3 mm |