Removing Rear Wing Joining Plate

WARNING: This page is about a different car, the 2023 Porsche Taycan and 2022 Porsche Taycan. However, it is still accessible from the selected car via links, so may be relevant.

Unscrew self-tapping screws.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Self-tapping screws
Remove part of the rear wing joining plate that is sticking up -1- at the marked line.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Separation line
Heat the marked bonding areas using > V.A.G 1416 - hot-air blower .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding area
Prise off the remaining piece -1- using a suitable tool and loosen penetrated joints by unrolling them in a downward direction -Arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Remaining piece