LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Taycan 4S >> Repair and Diagnosis >> Collision >> Body Panels >> 55 Lids, Flaps -- Y1A - TAYCAN (Y1A) >> 5540 Side Section Flap >> WM, 554019 Removing And Installing Electrical Side Section Flap (Module) >> Install Electrical Side Section Flap (Module) >> Installing Electrical Power Supply Flap (Module)

Installing Electrical Power Supply Flap (Module)

  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tighten screws on wing trim panel to wing rail with > Tightening torque 2.8 Nm (2 ftlb.)  .

    Tighten screw securing left charging socket to wing rail with > Tightening torque 4.5 Nm (3.25 ftlb.)  .

    Tighten nuts securing left charging socket to the body with > Tightening torque 8 Nm (6 ftlb.)  .

    Tighten screws securing charging socket to flap for electric power supply (module) with > Tightening torque 3 Nm (2 ftlb.)  .

scientia non olet · About LEMON Manuals