WM, 917025 Calibrating Lane Change Assist (Dynamic Calibration): Information

Information 

Read and follow safety instructions:

• Only perform calibration on public roads if the road and traffic conditions permit it. 
• Road traffic regulations must always be observed. 
• Other road users must not be endangered when performing calibration. 
• Only operate the vehicle on public roads when it is in road worthy condition. 

Information 

Preconditions for dynamic calibration:

• Left and right radar sensors are coded. 
• Component protection is taught. 
• There are no active fault codes stored except: P0B2105 Calibration; P0B2205 Calibration. 
• Any road that allows straight travel at a minimum of 17 mph (28 km/h) can be used as a calibration route. 
• Reference points such as buildings, vehicles, crash barriers, etc. must be located along the calibration route so that the radar sensor signals are reflected.