Removing Control Unit For Steering Wheel Electronics
WARNING:
Airbag contact unit not set correctly
- Malfunction in driver's airbag unit
→ When removing and installing the steering-column switch, turn the steering wheel so that the wheels are in straight-ahead position. This ensures that the airbag contact unit is locked in the central position. → Do not trap the cable of the airbag contact unit.
→ Check that the cable is routed correctly.
NOTE:
NOTIFICATION
Voltage peaks
Voltage peaks
- Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
→ Switch oft electrical loads before disconnecting or removing them.
Information
Always comply with the regulations for handling ESD-sensitive components'
- Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.
- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.
- The electrical pins or plug contacts must not be touched.