Removing Central Computer (Pcm)

NOTE: NOTIFICATION
Voltage peaks

Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).

→ Switch off electrical loads before disconnecting or removing them.

Information

Always comply with the regulations for handling ESD-sensitive components!

Always wear approved work clothes and shoes when carrying out assembly work.
Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation.
Do not touch electric pins and plug contacts.

Information

The number of electric plug connections will vary depending on equipment.

Loosen the central computer -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Central computer PCM
1. 1.1 Unclip clip -1- .
  Information
  
  Shown on the left side.
  
  Right side same as left side.
2. 1.2 Release clip -2- using a screwdriver.
  Alternatively, unlock with the > 9570/1 - removal tool .
3. 1.3 Draw the central computer -3- out of the holder -4- far enough -Arrow- until the electric plug connections are accessible.
Release electric plug connections -1- and disconnect them.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections
Remove central computer.