Preparing Rear Wheel Housing (Outer) (Front Section) For Installation

Fit in rear wheel housing (outer) (front section) and secure it to the body.
Prepare rear wheel housing (outer) (front section) for riveting.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Holes

LHD vehicle Drill bore holes for blind rivets through all sheetmetal plates using >diameter 6.6 mm .

RHD vehicle Punch hole for flow-form rivet.

> 5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS
Drill holes for blind rivets offset from existing holes. >diameter 6.6 mm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Holes
Remove rear wheel housing (outer) (front section).
Prepare rear wheel housing (outer) (front section) in the marked areas for joining.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparatory work

LHD vehicle Prepare area for bonding and riveting.

RHD vehicle Prepare area for bonding and resistance spot-welding.
Prepare rear wheel housing (outer) (front section) in the marked areas for joining.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparatory work

LHD vehicle Prepare area for bonding and riveting.

> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

RHD vehicle Prepare area for applying a full steel weld.
Prepare marked area on wheel housing reinforcement for bonding and resistance spot-welding.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparatory work