Installing Frame For Light

Information 

• Apply adhesive evenly over the entire bonding surface. 

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Apply adhesive on bonding areas of the body.

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   >Application depth 3 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas

2. Apply adhesive on front side member.

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   >Application depth 0.5 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas

   1. 2.1 Also apply a bead of adhesive all around the bonding surface.

      >Application depth 3 mm 

3. Rivet in frame for light.

   >BLIND RIVET 999.190.229.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Blind rivets

4. Rivet in frame for light.

   >BLIND RIVET 999.190.229.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Blind rivets