LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Taycan 4S >> Repair and Diagnosis (Single Page) >> Collision >> Body Panels >> 53 - Body Rear >> WM, 536155 Replacing Inner Side Section >> Subsequent Work >> Subsequent Work For Body Repairs (With Straightening System)

Subsequent Work For Body Repairs (With Straightening System)

  1. Remove vehicle from the straightening system.
  2. Clean joint areas and sheetmetal flanges with a wire brush.
  3. Prime joint areas and sheetmetal flanges with 2K primer.
  4. Restore standard seal with body sealant

    > 5X00IN42 SEAM SEALING

    Also seal the repair area carefully.

  5. Paint repair area and adjacent surfaces, if necessary.
  6. Restore standard underbody protection with underbody sealant

    > *** 5X00IN43 Underbody protection

  7. Apply standard cavity preservation

    > 5X00IN44 CAVITY PRESERVATION

    Also carefully apply cavity preservation to the repair area.

  8. Install removed accessories in the repair area.
scientia non olet · About LEMON Manuals