Preparing Seat-Well Floor For Installation

Information 

Mark cuts in accordance with the new part. Make sure to leave an overlap of approx. 20 mm with respect to the body.

1. Mark the new seat-well floor and cut it.
2. Position the seat-well floor and secure it to the body.
3. Preparing seat-well floor for joining.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Joint connections

   1. 3.1 Drill holes for countersunk blind rivets -LHD vehicle -  through both sheet metal panels with >diameter 6.5 mm  .
   2. 3.2 Counterbore the rivet holes -LHD vehicle -  using >VAS 6957 - 100° countersink  .
   3. 3.3 Drill holes -RHD vehicle -  for steel plug-welding using >diameter 8 mm  .
4. Remove seat-well floor.
5. Preparing seat-well floor for joining.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Joint areas

   1. 5.1 Prepare seat-well floor in areas -LHD vehicle -  for bonding and riveting.

      > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   2. 5.2 Prepare seat-well floor in areas -RHD vehicle -  for steel welding.