Preparing Longitudinal Member Reinforcement For Installation

Position longitudinal member reinforcement and secure it to the body.
Drill bore hole for blind rivets -LHD vehicle - through both sheetmetal plates with >diameter 6.6 mm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Joints
Remove longitudinal member reinforcement.
Drill holes for steel plug-welding using >diameter 8 mm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Longitudinal member reinforcement
Prepare rear longitudinal member reinforcement for joining.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Joint areas
1. 5.1 Prepare front longitudinal member reinforcement in areas -LHD vehicle - for bonding and riveting.
  > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00
2. 5.2 Preparing longitudinal member reinforcement in area -RHD vehicle - for steel plug-welding.