Removing Wing Rail (Section)

Information 

The wing rail (section) need only be replaced if the outer side member (front section) or the A-pillar must be replaced.

1. Mark and make cuts -A -  and -B -  . >Distance from bottom edge of side part 230 mm  >Distance from bottom edge of side part 450 mm

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Cuts

2. Unscrew self-tapping screws.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Self-tapping screws

3. Drill out penetrated joints.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Clinch point

4. Heat bonding area using >V.A.G 1416 - hot-air blower  and remove wing rail (section) -1-  between the cuts.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area