LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Taycan 4S >> Repair and Diagnosis (Single Page) >> Collision >> Body Panels >> 51 - Body Center, Roof, Frame >> WM, 514255 Replacing B-Pillar Reinforcement >> Removing Side Member Reinforcement (Section)

Removing Side Member Reinforcement (Section)

  1. Cut notches on the side member (section)
    G14406816Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Notch

    Information 

    Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

    1. 1.1 Mark and make cuts -LHD vehicle -  and -RHD vehicle -  .
    2. 1.2 Drill out spot welds using >VAS 882 001 - spot-weld remover  .
  2. Remove side member reinforcement (section).
scientia non olet · About LEMON Manuals