Removing The Side Member (Inner) Reinforcement Section

Information 

Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

1. Mark and make cut -A-  . >Distance 415 mm 
   Fig 1: Checking Side Member (Inner) Reinforcement Section Cutting Dimension

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Cut

2. Loosen the side member (inner) reinforcement section.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Steel welding

   1. 2.1 Drill out spotwelds using >V.A.G 1731 - pneumatic spotweld remover, Vario Drill WS 90  .
   2. 2.2 Grind down welded seams.
3. Remove the side member (inner) reinforcement section.