Installing A-Pillar

Information 

• Apply adhesive evenly over the entire bonding surface. 

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Tack on sheetmetal insert used as a welding backing strip on the body.

   > 5X00IN10 WELDING ALUMINIUM

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Sheetmetal insert

2. Install A-pillar, check that it fits perfectly and secure it.
3. Weld flow-form welding rivets through bores on the body.

   > 5X00IN29 REPLACING FRICTION ELEMENT WELDED JOINT

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Friction element welded joints

4. Remove A-pillar.
5. Apply adhesive on bonding areas of the body.

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   >Application depth 3 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   A-pillar

6. Apply adhesive on bonding areas of the body.

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   >Application depth 3 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding areas

7. Apply adhesive on A-pillar.

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   >Application depth 0.5 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area

   1. 7.1 Also apply a bead of adhesive all around the bonding surface.

      >Application depth 3 mm 

8. Install A-pillar.
9. Press flow-form welding rivets.

   > 5X00IN29 REPLACING FRICTION ELEMENT WELDED JOINT

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Flow-form welding rivets

10. Screw in self-tapping screws -1-  .

    > 5X00IN24 SETTING SELF-TAPPING SCREWS

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Self-tapping screws

11. Apply full aluminum weld on A-pillar.

    > Welding aluminum 

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Welding area

12. Bend over folded edges in the front door aperture using >VAS 6635 - crimping pliers set, 4-piece  .

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Folded edges