Removing Bottom Half Of Roof Cross Member At The Front

Information 

Only drill hole through the top sheet-metal panel. Do not damage the sheet-metal panel underneath.

Information 

• Some of the repair illustrations show only one side of the vehicle or a similar component. 
• Naturally, some steps also have to be performed on the opposite side of the vehicle as well. 

1. Drill out spotwelds using >VAS 882 001 - Spot-weld remover  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Spotwelds

2. Remove bottom half of roof cross member at the front.