Removing Roof Pillar (Outer Reinforcement)

Information 

Only drill hole through the top sheet-metal panel. Do not damage the sheet-metal panel underneath.

1. Drill out spotwelds using >VAS 882 001 - spotweld remover  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Spotwelds

2. Drill out spotwelds using >VAS 882 001 - spotweld remover  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Spotwelds

3. Heat bonding areas using >V.A.G 1416 - hot-air blower  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area

4. Remove roof pillar (outer reinforcement).