LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Taycan 4S >> Repair and Diagnosis (Single Page) >> Collision >> Body Panels >> 50 - Body Rear >> WM, 503419 Removing And Installing Cross Member >> Installing Cross Member

Installing Cross Member

  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1. Tighten screw.

      >Tightening torque 55 Nm 

      Information 

      New screws must be used.

    2. 1.2. Tighten screws.

      >Tightening torque 50 Nm 

      >Torque angle 180 ° 

scientia non olet · About LEMON Manuals