LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Taycan 4S >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> 63 - Bumpers >> WM, 635019 Removing And Installing Rear Bumper >> Installing Rear Bumper

Installing Rear Bumper

Information 

Use new screws following removal.

  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tighten screws on rear bumper to >Initial tightening 20 (15 ftlb.) Nm  >Final tightening + 45 °  .

    Tighten screws on rear bumper to >Initial tightening 20 (15 ftlb.) Nm  >Final tightening + 45 °  .

scientia non olet · About LEMON Manuals