Making Ground Connection Using A Through Bolt

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Diagram

-A-  > COUNTERSUNK SCREW 999.073.549.01 

-B-  > HEXAGON NUT 900.377.003.01 

-C-  Component 1

-D-  Component 2

-E-  Adhesive

-F-  Sealing compound

1. Drill a hole. > diameter 4 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Drilling hole

2. Remove dirt and primer on both sides using an end brush > *** 9399/3 - end brush.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing primer

3. Drill out the bore. > diameter 8 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Drilling out bore

4. De-burr the bore on both sides.
5. Fit countersunk screw through the bore and secure it with a hexagon nut. > COUNTERSUNK SCREW 999.073.549.01  > HEXAGON NUT 900.377.003.01 
6. Tighten threaded joint to the specified torque. > Tightening torque 15 (11 ftlb.) Nm 
7. Seal threaded joint.