General Information
WARNING:
Toxic substances
- Danger of poisoning or suffocation
- Danger of burns to the eyes and skin
→ Ventilate the work area well.
→ Never ingest or inhale.
→ Read specific information on the Hazard Sheet.
→ Wear personal protective gear.
→ Do not smoke, eat or drink in the work area.
Information
- The volume of the structural foam will expand by approx. 0 - 30 % in cavities. When filling large cavities, the chemical reaction can cause strong heat generation.
- Remove fresh foam residues immediately with a cloth soaked in acetone. Hardened foam residues can only be removed mechanically afterwards.
Information
- In addition to this Service Information, observe the relevant job descriptions for body repairs!
Information
- The vehicle, components and adhesives must be brought to processing temperature (acclimatised) before starting work. The processing temperature must be maintained for 30 minutes before starting to work on the bonding surfaces.
- Bonding surfaces must be free of oil, dirt, moisture and paint and oxide coatings.
- Do not touch the cleaned surfaces in order to avoid transferring sweat from your hands or dirt to the bonding surfaces.
- Silicone and Teflon sprays cannot be used anywhere in the workshop area.