Installing Front Window Guide

Information 

Make sure not to damage the front door window.

Information 

• Replace screws. 

1. Installation is performed in reverse order. Pay particular attention to the following:

   Pre-assemble front window guide before installation.

   Tighten bottom screw to > Tightening torque 8 Nm (5.9 ftlb.)  .

   Tighten screws at the top to > Tightening torque 7 Nm (5.2 ftlb.)  .

   Information 

   The adhesive pad cannot be pulled off without damaging it and must always be replaced.

2. Stick new adhesive pad on firmly.
   1. 2.1 Position adhesive pad so that the assembly opening is completely covered.
   2. 2.2 Press adhesive pad on firmly.