Loosening Main Wire Harness In Luggage Compartment (Rear)
- Risk of damage to lines
→ The main wire harness contains all airbag lines, antenna lines and optical waveguides.
→ The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.
→ If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.
- Release and disconnect electric plug connections for airbag sensor on left C-pillar.
- Unclip clips -1-
.
Clips
- Release and disconnect electric plug connection on rear left shock absorber.
- Release and disconnect electric plug connections on DME control unit.
> Refer to the appropriate service information.
- Disconnect main wire harness in luggage compartment, rear left -1-
.
Disconnect main wire harness in luggage compartment, rear left
- 5.1 Unclip cable duct -2- (-arrow- ).
- 5.2 Unscrew and remove screws -3- .
- 5.3 Unclip clip -4- .
- 5.4 Unscrew nuts on ground points at left C-pillar -5- .
- Release and disconnect electric plug connections for tailgate control unit.
- Release and disconnect electric plug connection for acoustic simulator control unit.
> Refer to the appropriate service information.
- Remove control unit for chassis control.
> 431619 REMOVING AND INSTALLING CONTROL UNIT FOR CHASSIS CONTROL
- Release and disconnect electric plug connections on subwoofer.
- Guide grommets at rear left -1-
out of body -Arrows-
.
Grommets, rear left
- Unclip clips -1-
.
Clips
- Release and disconnect electric plug connection on airbag sensor at lock carrier.
- Release and disconnect electric plug connection for rear KESSY/PAS antenna.
- Unclip connection point holder for lock carrier -1-
and clips -2-
.
Connection point holder for lock carrier holder
- Release electric plug connections from the rear-differential lock control unit and disconnect.
> 397519 REMOVING AND INSTALLING CONTROL UNIT FOR REAR-DIFFERENTIAL LOCK
- Unclip clips -1-
.
Clips
- Guide grommets at rear right -1-
out of body -Arrows-
.
Grommets at rear right
- Release and disconnect electric plug connections on rear-end electronics control unit.
> 578919 REMOVING AND INSTALLING CONTROL UNIT FOR REAR-END ELECTRONICS
- Release and disconnect electric plug connection on rear right shock absorber.
- Loosen rear fuse box.
- Disconnect main wire harness in rear right of luggage compartment -1-
.
Main wire harness in luggage compartment, rear right
- 21.1 Unclip cable duct -2- (-arrow A- ).
- 21.2 Unscrew nuts on ground points at right C-pillar -3- .
- 21.3 Unclip rear right connection points holder -4- (-arrow B- ).
- 21.4 Unclip clips -5- .
- Release and disconnect electric plug connections for airbag sensor on right C-pillar.
- Unclip clips -1-
.
Clips