Removing Night Vision System Control Unit

NOTE: NOTIFICATION
Voltage peaks

Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).

→ Switch off electrical loads before disconnecting or removing them.

Information

Always comply with the regulations for handling ESD-sensitive components!

Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.
The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.
The electrical pins or plug contacts must not be touched.

Remove Night vision system control unit -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Night vision system control unit
1.1 Release and unplug electric plug connections -2- .
1.2 Unclip clip -3- .
1.3 Remove Night vision system control unit -1- by pulling it upwards -arrow-.