LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2020 >> Panamera Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 82 (69 Occupant Protection/Personal Protection - Wagon -- 971 - PANAMERA (971)) >> WM, 693619 Removing And Installing Adjustment Fitting (Seat Belt Height Adjuster) >> Installing Adjustment Fitting (Seat Belt Height Adjuster)

Installing Adjustment Fitting (Seat Belt Height Adjuster)

WARNING: This page is about a different variant/trim than selected.

Information 

Always replace screws on the three-point seat belt. Micro-self-locking screws must not be adjusted or loosened and then screwed on again.

  1. Installation is performed in reverse order. Pay particular attention to the following:

    Tightening torque for belt deflector screw: > Tightening torque 50 Nm (36.9 ftlb.) 

    Tightening torque for screw on adjustment fitting (seat belt height adjuster): > Tightening torque 33 Nm (24.3 ftlb.) 

scientia non olet · About LEMON Manuals