Checking Locking Effect Of Automatic Belt Device
- Danger to other people on the roads
→ Perform drive tests on a stretch of road with no traffic.
The automatic belt device has two locking functions
- The first locking function is triggered by pulling the seat belt out quickly (belt extension acceleration).
- Pull the belt strap out of the automatic belt device with a strong jerk.
If no locking effect occurs, replace the entire seat belt and seat-belt buckle.
> 691119 REMOVING AND INSTALLING FRONT THREE-POINT BELT
> 691219 REMOVING AND INSTALLING REAR THREE-POINT BELT
> 692419 REMOVING AND INSTALLING FRONT BELT LOCK
> 692519 REMOVING AND INSTALLING REAR BELT LOCK
In the event of faults in the extension or retraction of the seat belt, check whether the locking lug of the automatic belt device is engaged correctly in the sheetmetal bracket on the body.
- The second locking function is triggered by a change in the sequence of vehicle movement (vehicle-dependent locking function).
- Fasten the seat belt.
- Accelerate to 20 km/h (12 mph) and perform emergency stop.
If the seat belt is not locked by the blocking mechanism when you brake, replace the entire seat belt and seat-belt buckle.
> 691119 REMOVING AND INSTALLING FRONT THREE-POINT BELT
> 691219 REMOVING AND INSTALLING REAR THREE-POINT BELT