Installing D-Pillar Trim Panel
WARNING: This page is about a different variant/trim than selected.
Information
After fitting the D-pillar trim panel, the rear lid seal must be positioned correctly over the D-pillar trim panel.
Information
Always use new bolts following removal.
- Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for screw on cover for belt guide: > Tightening torque 5.6 Nm (4 ftlb.)
Tightening torque for screws for D-pillar trim panel: > Tightening torque 5.6 Nm (4 ftlb.)
Tightening torque for bolts on D-pillar trim panel: > Tightening torque 12.5 Nm (9.2 ftlb.)