Subsequent Work (V6 Monoturbo)
WARNING: This page is about a different variant/trim than selected.
- Fit pressure hose -1-
on throttle valve.
- 1.1 Push pressure hose -1-
onto the throttle valve and tighten screw-type clamp -2-
to > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.4 ftlb.)
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Pressure hose on throttle valve
- Install drive belt for generator.
> WM, 137819 REMOVING AND INSTALLING DRIVE BELT (V6)
- Check engine-oil level.
> CHECKING ENGINE-OIL LEVEL