Replacing Control Mechanism For Transmission
WARNING: This page is about a different variant/trim than selected.
Information
The instructions in the PIWIS Tester take precedence and in the event of a discrepancy, these are the instructions that must be followed. A discrepancy may arise with later software versions.
- Install new control mechanism for transmission.
- Connect battery charger.
- > 9900 - PIWIS Tester 3
must now be connected.
- 3.1 Maintenance/repairs must now be selected.
- 3.2 Select Transmission electronics (PDK II) control unit.
- 3.3 Select Calibration (complete process).
- 3.4 Select and start Calibration of transmission after part replacement.