Preliminary Work
WARNING: This page is about a different variant/trim than selected.
NOTE:
Dirt and contamination
- Risk of damage to units or components
→ Protect components from dirt and contamination.
→ Clean or replace dirty components.
Information
- The pressure sensors for clutch 1 and 2 (K1 and K2) are identical parts.
- The pressure sensors can be diagnosed using a fault code and this is used to detect the defective sensor in the PIWIS Tester.
Information
- If a pressure sensor is removed on a vehicle with a mileage of around 90, 000 km (56, 000 mls), the hydraulic oil should be changed (service interval at the same time).
- Remove ATF pan.
- Remove hydraulic control unit.