Removing All-Wheel Final Drive
WARNING: This page is about a different variant/trim than selected.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
- Fit impact puller.
- 1.1 > 9799 - Impact puller
must be fitted at the groove in the connecting shaft using four screws -1-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Fitting tool (similar to illustration)
- Loosen connecting shaft.
- 2.1 Use > 9799 - impact puller
to remove connecting shaft from all-wheel final drive -arrow-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Removing and fitting connecting shaft (similar to illustration)
- Remove console.
- 3.1 Unscrew fastening screws -1-
and remove console -2-
.
- 3.2 Remove circlip -3-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Final drive console
- Remove coolant lines -1-
.
- 4.1 Unclip positive cable at three places.
- 4.2 Unscrew screws -2 and 3-
and nut -4-
.
- 4.3 Loosen clamps -5-
.
- 4.4 Remove coolant lines -1-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Coolant lines
- Remove right engine mount -2-
.
- 5.1 Unscrew screws -1-
and remove engine mount -2-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Right engine mount
- Remove right engine carrier -2-
.
- 6.1 Unscrew screws -1-
and remove engine carrier -2-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Right engine carrier
- Remove all-wheel final drive.
- 7.1 Unscrew screws -4-
and remove all-wheel final drive -3-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Front-axle final drive