Removing Three-Point Belt, Front
- Triggering of seat-belt pretensioner unit
→ Observe safety regulations for handling seat-belt pretensioner units.
> 6X00IN HANDLING AND REPLACING AIRBAG AND SEAT-BELT PRETENSIONER UNITS
→ Observe disposal regulations for seat-belt pretensioner units.
> 6X00IN DISPOSAL OF AIRBAG AND SEAT-BELT PRETENSIONER UNITS
→ After disconnecting the battery, wait 1 minute before disconnecting the seat-belt pretensioner unit.
→ Remove ignition key and disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier is avoided.
> 2706IN00 Work instructions after disconnecting the battery
→ If removed for an extended period, the seat-belt pretensioner unit must be stored in a safe place.
→ Transport the seat-belt pretensioner unit in such a way that the seat belt can retract safely if it is actuated.
Information
Dispose of replaced and non-ignited airbag and seat-belt pretensioner units in accordance with local legal requirements and transport regulations.
- Move the seat forward and upward.
- Pull trim panel on belt fastening point -2-
up off the front seat.
Removing trim panel on belt fastening point
- Disconnect ground strap for battery.
- Unscrew screw -3-
and loosen seat belt mount -4-
.
Seat belt mount
- Unscrew screw -5-
and remove belt deflector -6-
.
Belt deflector
- Unscrew screw -7-
and remove retaining bar -8-
.
Retaining bar
- Remove belt reel -1-
.
Belt reel
- 7.1 Release electric plug connections -9- and disconnect them.
- 7.2 Push the floor covering aside and unscrew screw -10- .
- 7.3 Press seat belt aside, unscrew screw -11- and remove belt reel -1- .